Siemens SCALANCE XM-400 Configuration Manual page 729

Syntax
Call up the command with the following parameters:
deny udp {any | host <src-ip> | <network-src-ip> <mask>} [{ gt <port-number(1-65535)>
| lt <port-number(1-65535)> | eq <port-number(1-65535)> | range <port-number (1-
65535)> <port-number (1-65535)>}] [{any | host <dest-ip> | <network-dest-ip> <mask>}]
[{ gt <port-number(1-65535)> | lt <port-number(1-65535)> | eq <port-number(1-65535)>
| range <port-number (1-65535)> <port-number (1-65535)>}] [dscp<value(0-63)>]
The parameters have the following meaning:
Parameter
any
host
src-ip
network-src-ip
mask
port-number
gt
lt
eq
range
any
host
dest-ip
network-dest-ip
mask
dscp
value
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The IP access list for UDP datagrams has been configured.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Blocks all incoming TCP segments
Keyword for a single IP address
Source IP address
Network source address
Corresponding subnet mask
Port number
Keyword for port numbers higher than
the specified number (gt: greater than).
Keyword for port numbers lower than
the specified number (lt: less than).
Keyword for a specific port number
(eq:equal).
Keyword for a range of port numbers.
Following this, the first and last port
number of the range is specified.
Blocks all outgoing TCP segments
Keyword for a single IP address
Destination IP address
Network destination address
Corresponding subnet mask
Keyword for the Differentiated Services
Codepoint
Value for the Differentiated Services
Codepoint
Security and authentication
11.4 IP access control list
Range of values / note
-
-
Enter a valid IP address.
Enter a valid combination of IP
address and subnet mask.
1 ... 65535
-
-
-
-
-
-
Enter a valid IP address.
Enter a valid combination of IP
address and subnet mask.
-
0 ... 63
729