No Transparent-Vlan - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
Syntax
Call the command without parameters:
transparent-vlan
Result
The VLAN is changed to transparent mode.
Further notes
● All ports that were not members or untagged members in the relevant VLAN are
automatically set to the Forbidden status after the command executes.
● As long as a VLAN is configured as a transparent VLAN, the ports belonging to this VLAN
cannot be modified.
● Note that only one VLAN can be configured as a transparent VLAN.
You disable the setting with the
6.1.4.6

no transparent-vlan

Description
With this command, you return a VLAN from the transparent mode to the mode conforming
with the standard.
Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameters:
no transparent-vlan
Result
If the VLAN was configured as a transparent VLAN, this function is deactivated.
This means the following:
● All transparent ports become untagged members in this VLAN
● The port VLAN ID of the previous transparent ports remains set to the ID of this VLAN.
● All other ports remain marked as forbidden in this VLAN.
204
command.
no transparent-vlan
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10