Siemens SCALANCE XM-400 Configuration Manual page 337

Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ipv6 dhcp relay [destination <prefix> {link-local | <prefix Len> } [interface
{Vlan <vlan-id (1-4094)> | <interface-type> <interface-id>}]]
The parameters have the following meaning:
Parameters
destination
prefix
link-local
prefix Len
interface
vlan
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The DHCPv6 relay agent is disabled.
Further notes
You enable the DHCPv6 relay agent with the
You configure the interface as a router port with the
You display the setting with the
You display the statistics with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Keyword for the IPv6 address of the
destination DHCPv6 server
IPv6 address
Link local address of the DHCP relay
agent
Number of bits belonging to the prefix
(from left to right)
Shows that an interface description
follows
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
ipv6 dhcp relay command.
show ipv6 dhcp interface
show ipv6 dhcp relay statistics
Network protocols
7.6 DHCPv6 Relay Agent (IPv6)
Range of values / note
-
Enter a valid IPv6 address.
-
1 ... 128 bits
128: The node (host) itself
-
-
1 ... 4094
Enter a valid interface.
command.
no switchport
command.
command.
337