Ipv6 Ospf Linklsasuppress - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
9.3.4.7

ipv6 ospf linkLSASuppress

Description
With this command, you disable the distribution of the LAS type "Link" and the entry is
removed from the database of the routers that are reachable via the link. The routers can
determine the IPv6 address of the next router (next hop) via the IPv6 source address from
the hello packet of the next router.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● The OSPFv3 network is a point-to-point or point-to-multipoint network.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ipv6 ospf linkLSASuppress
Result
The LAS type "Link" is not distributed.
Further notes
You disable the setting with the
You configure the OSPF network with the
You enable OSPFv3 routing with the
You display information about the configuration with the
command.
538
no ipv6 ospf linkLSASuppres
ipv6 ospf network
ipv6 router ospf
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
command.
command.
show ipv6 ospf interface