Spanning-Tree Layer2-Gateway-Port - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree bpdufilter{disable|enable}
The parameters have the following meaning:
Parameter
disable
enable
Result
The BPDU transmit status is configured.
6.3.5.10

spanning-tree layer2-gateway-port

Description
With this command, you configure a port as a layer 2 gateway port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
spanning-tree layer2-gateway-port
Result
The port is configured as a layer 2 gateway port.
242
Description
The transfer of BPDU packets is disa-
bled for the port
The transfer of BPDU packets is ena-
bled for the port
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
Default: disabled
-
Configuration Manual, 11/2015, C79000-G8976-C252-10