Poe; The "Show" Commands; Show Poe Status - Siemens SCALANCE XM-400 Configuration Manual

3.5

PoE

3.5.1

The "show" commands

This section describes commands with which you display various settings.
Note
The interface is a Gigabit Ethernet interface.
3.5.1.1

show poe status

Description
This command shows specific information for all or for a selected PoE interface (PoE: Power
over Ethernet).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show poe status [interface <interface-type> <interface-id>]
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
If you use the command without setting parameters, information about all PoE interfaces is
displayed.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The information for the selected PoE interface is displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
or
cli#
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Configuration
Range of values / note
-
Enter a valid interface.
3.5 PoE
119