Show Ipv6 Dhcp Pd Sub-Client Interfaces - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
show ipv6 dhcp interface
id>}]
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-
type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The information is displayed.
7.4.1.3

show ipv6 dhcp pd sub-client interfaces

Description
This command shows the configuration of the DHCPv6 PD sub-client
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show ipv6 dhcp pd sub-client interfaces
Result
The information is displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
[{vlan <vlan-id(1-4094)> | <interface-type> <interface-
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Network protocols
7.4 DHCPv6 client (IPv6)
Range of values / note
-
1 ... 4094
Enter a valid interface.
311