Show Ip Interface - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interfaces
[{<interface-type><interface-id>]|{vlan<vlan-id(1-4094)>}]counters
The parameters have the following meaning:
Parameter
interface-type
interface-id
vlan
vlan-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available counters.
Result
The counters of the selected interfaces are displayed.
3.1.1.9

show ip interface

Description
This command shows the configuration of one, several or all IPv4 interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
62
or
cli#
Description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
or
cli#
Range of values / note
Enter a valid interface.
-
1 ... 4094
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10