Commands In The Global Configuration Mode; Login Authentication - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
show radius server [{<ucast_addr> | <ip6_addr>}]
The parameters have the following meaning:
Parameter
ucast_addr
ip6_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If no parameters are specified, all configured RADIUS servers are displayed.
Result
The RADIUS server configuration is displayed.
11.2.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
11.2.2.1

login authentication

Description
With this command, you enable authentication via a RADIUS server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
login authentication {radius | local-and-radius | radius-fallback-local}
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Value for an IPv4 unicast address
Value for an IPv6 address
configure terminal
Security and authentication
Range of values / note
Enter a valid unicast address.
Enter a valid IPv6 address.
command to change to this mode.
or command and are then in the
end exit
11.2 RADIUS client
691