Layer 3 functions
9.6 RIPv2 (IPv4)
9.6.4.1
Note_on_layer 3
Note
These commands are available only with layer 3.
9.6.4.2
ip rip default route originate
Description
This command enables the forwarding of a default route.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ip rip default route originate <metric(1-15)>
The parameter has the following meaning:
Parameter
metric
Result
The default route is forwarded.
9.6.4.3
no ip rip default route originate
Description
This command disables the distribution of the default routes.
604
Description
Value for the metric information.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 15
Configuration Manual, 11/2015, C79000-G8976-C252-10