No Ipv6 Router Rip; Commands In The Ripng Router Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
9.7.2.2

no ipv6 router rip

Description
With this command, you enable RIPng routing on the device.
Note
This command is available only with layer 3 (IPv6).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ipv6 router rip
Result
Routing with RIPng is disabled.
Further notes
You enable routing with RIP with the
You display the setting and other information with the
9.7.3

Commands in the RIPng Router configuration mode

This section describes commands that you can call up in the Router Configuration mode.
In the global configuration mode, enter the
mode.
Commands relating to other topics that can be called in the Global Configuration mode can
be found in the relevant sections.
● If you exit the Router Configuration mode with the
Global Configuration mode.
● If you exit the Router Configuration mode with the
Privileged EXEC mode.
612
command.
ipv6 router rip
show ipv6 rip
command to change to this
ipv6 router rip
command, you return to the
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.