No Router Vrrp3; Commands In The Vrrp3 Router Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

9.5.3.2

no router vrrp3

Description
With this command, you disable routing with VRRPv3.
Note
This command is available only with layer 3.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no router vrrp3
Result
Routing with VRRPv3 is disabled.
Further notes
You enable routing with VRRPv3 with the
9.5.4

Commands in the VRRP3 Router configuration mode

This section describes commands that you can call up in the VRRP3 Router configuration
mode.
In the Global configuration mode, enter the
● If you exit the VRRP3 Router configuration mode with the
the Global configuration mode.
● If you exit the VRRP3 Router configuration mode with the
Privileged EXEC mode.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
router vrrp3
command to change to this mode.
router vrrp3
exit
end
Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
command, you return to
command, you return to the
573