8.5 Unicast; The "Show" Commands; Show Unicast-Block Config - Siemens SCALANCE XM-400 Configuration Manual

Result
The "Wait for standby partner" function is disabled.
8.5 Unicast
The commands in this section configure the procedures for handling Unicast frames.
The commands allow the following:
● Filtering of Unicast frames
● Blocking of ports
● Automatic learning of Unicast
● Blocking unknown Unicast frames.
With the "show" commands, you can display the configuration data.
8.5.1

The "show" commands

This section describes commands with which you display various settings.
8.5.1.1

show unicast-block config

Description
This command shows the unicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show unicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 39)".
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
or
cli#
Description
Keyword for a port description
Type or speed of the interface
Module no. and port no. of the interface
Layer 2 management protocols

8.5 Unicast

Range of values / note
-
Enter a valid interface
417