No Ip Ospf Authentication - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
ip ospf authentication [{message-digest}]
The parameters have the following meaning:
Parameter
message-digest
If you enter the command without parameters, an unencrypted password is used for
authentication.
Result
The type of authentication is specified.
Further notes
You remove the type of authentication with the
You create the password for MD5 with the
You create the password with the
9.2.4.2

no ip ospf authentication

Description
With this command, you reset the type of authentication back to the default value.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
ip ospf authentication
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Authentication using MD5
ip ospf message-digest-key
ip ospf authentication
Range of values / note
-
no ip ospf authentication
command.
Layer 3 functions
9.2 OSPFv2 (IPv4)
command.
command.
483