Ip Ospf Transmit-Delay; No Ip Ospf Transmit-Delay - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
9.2.4.15

ip ospf transmit-delay

Description
With this command, you specify the time required to transfer and LSA message.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf transmit-delay <seconds (0 - 3600)>
The parameter has the following meaning:
Parameter
seconds
Result
The interval is specified.
Further notes
You delete the interval with the
9.2.4.16

no ip ospf transmit-delay

Description
With this command, you delete the interval.
Note
This command is available only with layer 3.
494
Description
Interval in seconds
no ip ospf transmit-delay
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
0 - 3600
command.
Configuration Manual, 11/2015, C79000-G8976-C252-10