Channel-Group; No Channel-Group - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.2 Link aggregation
6.2.3.1

channel-group

Description
With this command, you add an interface to an Etherchannel.
Requirement
With the
logical interface for an Etherchannel.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
channel-group <channel-group-number(1-8)> mode{on|active|passive}
The parameters have the following meaning:
Parameter
channel-group-
number
on
active
passive
Result
The Etherchannel is configured.
6.2.3.2

no channel-group

Description
With this command, you remove the interface from an Etherchannel.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
210
interface po <channel-group-id(1-8)>
Description
Number of the Channel-Group
Adds the interface without LACP to a
Channel-Group.
This corresponds to manual bundling.
The negotiation of a connection via
LACP is started unconditionally
The negotiation of a connection via
LACP is started when an LACP packet
arrives from the connection partner
command, you have already generated a
Range of values / note
1 ... 8
-
-
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10