Show Ip Ospf Virtual-Links - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
Syntax
Call up the command with the following parameters:
show ip ospf retransmission-list
[<neighbor-id>]
[{
}]
The parameters have the following meaning:
Parameter
neighbor-id
vlan
vlan-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the list is displayed for all
neighbors.
Result
The list is displayed.
9.2.1.10

show ip ospf virtual-links

Description
This command shows an overview of the virtual connections.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ip ospf virtual-links
448
vlan <vlan-id (1-4094)>|<interface-type> <interface-id>
Description
Router ID of the neighbor
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
or
cli#
Range of values / note
Enter the router ID. The router ID
consists of 4 numbers each be-
tween 0 and 255.
-
1 ... 4094
Enter a valid interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10