No Client Config - Siemens SCALANCE XM-400 Configuration Manual

Result
The function of the client selected for the transfer is enabled.
Further notes
You display the status of the events and the clients with the
You disable a client with the
12.1.6.3

no client config

Description
With this command, you disable one of the clients that processes or forwards the messages
of the device.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no client config {syslog|trap|email|all}
The parameters have the following meaning:
Parameter
syslog
trap
email
all
Result
The client selected for the transfer is disabled.
Further notes
You display the status of the events and the clients with the
You enable the function with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
no client config
Description
Disables the client that sends the messages to the Syslog server
Disables the client that sends the SNMP traps
Disables the client that sends the e-mails
Disables all clients at once
client config
12.1 Event and fault handling
show events config
show events config
command.
Diagnostics
command.
command.
769