No Ports - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
The parameters have the following meaning:
Parameter
interface-type
/a-b,0/c,...
port-channel
a,b,c-d
untagged
all
forbidden
name
vlan-name
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The existing VLAN configuration is replaced. To add individual interfaces, you need to
recreate the full list.
Further notes
You display details of the function with the
You reset the settings with the
6.1.4.2

no ports

Description
With this command, you remove ports from a VLAN.
Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
200
Description
Type or speed of the interface
Port no. of the interface
Keyword for a port channel
Port no. of the interface
Keyword for interfaces or ports that
transfer data packets without VLAN
marking
Specifies that all interfaces or ports are
set to "untagged"
Keyword for forbidden interfaces or
ports
Keyword for the name assignment
Name of the VLAN
show vlan
command.
no ports
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
Enter a valid interface.
-
Enter a valid interface name
-
-
-
-
max. 32 characters
command.
Configuration Manual, 11/2015, C79000-G8976-C252-10