Vrrp Priority - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> ipv4 <ucast_addr > [secondary]}]
The parameters have the following meaning:
Parameter
vrid
ucast_addr
secondary
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The IPv4 address is removed from the virtual router.
Further notes
You configure a VRRP interface with the
You assign IPv4 addresses to a virtual router with the
You display the IPv4 addresses with the
9.4.4.8

vrrp priority

Description
With this command, you specify the priority of the virtual router. The current master router is
automatically given 255. All other priorities can be distributed freely among the VRRP
routers. The higher the priority, the earlier the VRRP router becomes "Master".
Note
This command is available only with layer 3.
Requirement
● An IPv4 address is assigned to the virtual router.
● You are in the VRRP Interface configuration mode
.The command prompt is:
cli(config-vrrp-if)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
ID of the virtual router
Value for an IPv4 unicast address
Secondary IP addresses
interface
show vrrp interface - vrid
9.4 VRRPv2 (IPv4)
Range of values / note
1 ... 255
Enter a valid IPv4 unicast ad-
dress.
-
command.
command.
vrrp associated-ip
command.
Layer 3 functions
563