Multicast-Block - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
Requirement
● The Interface must be shut down.
● You are in the Interface configuration mode.
● The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
mtu <frame-size(64-9216)>
The parameter has the following meaning:
Parameter
frame-size
Result
The setting for the size of the MTU is configured.
Further notes
You can shut down the interface with the
You display this setting with the
You display this setting and other information with the
3.1.13.11

multicast-block

Description
With this command, you enable the blocking of multicast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
multicast-block
94
Description
Size of the MTU in bytes
shutdown
show interface mtu
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
64 ... 9216
Default: 1514
command.
command.
show interfaces
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.