Set Dot1X Guest-Vlan Mac-Addr Count - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x guest-vlan reset [mac <aa:aa:aa:aa:aa:aa>]
The parameter has the following meaning:
Parameter
mac
Result
The specified MAC address or all MAC addresses are no longer assigned to the guest
VLAN.
11.7.3.6

set dot1x guest-vlan mac-addr count

Description
With this command, you specify how many AC addresses can be authenticated on the port
at the same time.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
set dot1x guest-vlan mac-addr count <num-of-addresses (1-100)>
The parameter has the following meaning:
Parameter
num-of-addresses
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Keyword for the MAC address
MAC address to be removed from the
guest VLAN.
Description
Maximum number of devices
Security and authentication
11.7 Port Based Network Access Control
Range of values / note
-
aa:aa:aa:aa:aa:aa
Range of values / note
1 ... 100
749