Layer 3 functions
9.2 OSPFv2 (IPv4)
9.2.3.8
no area
Description
With this command, you remove or change an area of the type "Stub" or "NSSA".
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no area <area-id>
[
{ stub | nssa }
]
The parameters have the following meaning:
Parameter
area-id
stub
nssa
Result
The area is removed or changed.
460
Description
Range of values / note
Area-ID
enter a valid ID.
x.x.x.x
x = 0 ... 255
The area ID 0.0.0.0 is reserved for the backbone area
and cannot be deleted.
Stub area
--
NSSA area
--
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10