Ipv6 Rip Metric-Offset - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You display this setting and other information with the
You enable RIP routing with the
9.7.4.5

ipv6 rip metric-offset

Description
As default. the metric increases by 1 (metric offset) with incoming RIPng routes. With this
command, you can specify a different offset. The RIPng route is further distributed with the
new metric.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ipv6 rip metric-offset <integer (1-15)>
The parameter has the following meaning:
Parameter
integer
Result
The metric offset is configured.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
ipv6 rip.
Description
Metric offset
show ipv6 rip
command.
Range of values / note
1 ... 15
Default: 1
Layer 3 functions
9.7 RIPng (IPv6)
command.
623