Vrrp Primary-Ip - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> preempt
The parameter has the following meaning:
Parameter
vrid
Result
The function is disabled.
Further notes
You configure a VRRP interface with the
You assign IPv4 addresses to a virtual router with the
You enable the function with the
You can display the status of the function with the
show vrrp interface
9.4.4.6

vrrp primary-ip

Description
With this command, you specify the primary IPv4 address specified with the VRRP packets
as the source address.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
ID of the virtual router
interface
vrrp preempt
command.
Range of values / note
1 ... 255
command.
vrrp associated -ip
command.
show vrrp interface - vrid
Layer 3 functions
9.4 VRRPv2 (IPv4)
command.
or with the
561