Show Snmp Viewtree; Commands In The Global Configuration Mode; Snmpagent - Siemens SCALANCE XM-400 Configuration Manual

7.7.1.13

show snmp viewtree

Description
This command shows the settings for the SNMP tree views.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show snmp viewtree
Result
The settings for the SNMP tree views are displayed.
7.7.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.7.2.1

snmpagent

Description
With this command, you enable the SNMP agent function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
or
cli#
command to change to this mode.
configure terminal
or
end exit
Network protocols
command and are then in the
7.7 SNMP
347