No Ipv6 Dhcp Relay - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.6 DHCPv6 Relay Agent (IPv6)
Syntax
Call up the command with the following parameters:
ipv6 dhcp relay [destination <prefix> [interface {vlan <vlan-id (1-4094)> |
<interface-type> <interface-id>}]]
The parameters have the following meaning:
Parameters
destination
prefix
interface
vlan
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The DHCP Relay Agent is enabled.
Further notes
You disable the DHCPv6 relay agent with the
You configure the interface as a router port with the
You display the setting with the
You display the statistics with the
7.6.4.2

no ipv6 dhcp relay

Description
With this command, you disable the DHCPv6 relay agent. You can also remove the DHCPv6
servers.
336
Description
Keyword for the IPv6 address of the
destination DHCPv6 server
IPv6 address
Shows that an interface description
follows
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
no ipv6 dhcp relay
show ipv6 dhcp interface
show ipv6 dhcp relay statistics
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
-
Enter a valid IPv6 address.
-
-
1 ... 4094
Enter a valid interface.
command.
command.
no switchport
command.
command.
Configuration Manual, 11/2015, C79000-G8976-C252-10