Match Metric-Type - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
no match metric <value(0-0xffffff)>
The parameter has the following meaning:
Parameter
value
Result
The filter for the value of the metric is deleted.
Further notes
You create a filter for the value of the metric with the
You change to the Route maps configuration mode with the command
You display the setting and other information with the
9.8.3.9

match metric-type

Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the type of the metric.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Value of the metric
Range of values / note
0 ... 0xffffff
You can enter the value in decimal or hexadecimal.
match metric
show route-map
Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
command.
.
route-map
command.
635