No Vrrp Accept-Mode - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> accept-mode
The parameter has the following meaning:
Parameter
vrid
Result
The ping function to virtual IPv6 addresses is enabled.
Further notes
You disable the ping function for virtual IPv6 addresses with the
command.
You assign IP addresses to a virtual router with the
You can display the status of the function with the
show vrrp3 interface
9.5.5.2

no vrrp accept-mode

Description
With this command, you disable the ping function for virtual IPv6 addresses on the VRRP3
interface.
Note
This command is available only with layer 3.
Requirement
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
578
Description
ID of the virtual router
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 255
no vrrp accept-mode
vrrp associated -ip
show vrrp3 interface - vrid
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
or with the