No Multicast-Block; Negotiation - Siemens SCALANCE XM-400 Configuration Manual

Result
Multicast frames are blocked.
Further notes
You disable the blocking of multicast frames with the
3.1.13.12

no multicast-block

Description
With this command, you disable the blocking of multicast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no multicast-block
Result
The blocking of multicast frames is disabled.
Further notes
You enable the blocking of multicast frames with the
3.1.13.13

negotiation

Description
With this command, you enable autonegotiation of connection parameters on an interface.
Autonegotiation must be set for every interface of connected interfaces.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
no multicast-block
command.
mulitcast-block
Configuration
3.1 System
95