Vrrpv3 (Ipv4 / Ipv6); Clear Vrrp3 Statistics; The "Show" Commands - Siemens SCALANCE XM-400 Configuration Manual

9.5

VRRPv3 (IPv4 / IPv6)

This section describes the commands relevant for working with routing with VRRPv3.
Version 3 of VRRP is based on version 2.
Note
• Enable routing to be able to use VRRPv3.
• The commands are only available with layer 3 and only in conjunction with VLAN
interfaces. Router ports are not supported.
• Simultaneous operation of VRRP and VRRPv3 is not possible.
• VRRPv3 supports IPv4 and IPv6. Both can be configured and operated at the same time
with VRRP3.
9.5.1

clear vrrp3 statistics

Description
With this command, you reset the counters to zero.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
clear vrrp3 statistics
Result
The counters are reset.
Further notes
You display the table with the commands
vrid
9.5.2

The "show" commands

This section describes commands with which you display various settings.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
.
and
show vrrp3 interface
Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
show vrrp3 interface -
569