Commands In The Global Configuration Mode; Monitor; No Monitor - Siemens SCALANCE XM-400 Configuration Manual

12.4.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
12.4.2.1

monitor

Description
With this command, you enable the port mirroring function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
monitor
As default the function is "disabled".
Result
The port mirroring function is enabled.
Further notes
You can display the status of this function with the
You disable the function with the
12.4.2.2

no monitor

Description
With this command, you disable the port mirroring function.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
configure terminal
or
end exit
show monitor
command.
no monitor
12.4 Port Mirroring
command to change to this mode.
command and are then in the
command.
Diagnostics
797