No Router Rip - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
router rip
Result
Routing with RIP is enabled.
You are now in the Router configuration mode.
The command prompt is as follows:
cli (config-rip)#
Further notes
You disable the RIP protocol with the
9.6.2.3

no router rip

Description
With this command, you disable the RIP protocol.
Note
This command is available only in layer 3 (IPv4).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no router rip
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
no router rip
Layer 3 functions
9.6 RIPv2 (IPv4)
593