Ipv6 Mld Snooping Port-Purge-Interval - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 mld snooping clear counters [Vlan <vlanid (1-4094)>]
The parameters have the following meaning:
Parameter
vlan
vlan id
Result
The counters are reset.
8.7.2.4

ipv6 mld snooping port-purge-interval

Description
The time after which a port is deleted from the list if no MLD packets are received is known
as the purge time.
With this command, you configure this purge time for a port or for a VLAN in seconds.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 mld snooping port-purge-interval <(130 - 1225) seconds>
The parameters have the following meaning:
Parameter
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Keyword for a VLAN
Number of the addressed VLAN
Description
Value for the purge time in seconds
Layer 2 management protocols
8.7 MLD Snooping (IPv6)
Range of values / note
-
1 ... 4094
Range of values / note
130 ... 1225
Default: 260
433