Redistribute - Siemens SCALANCE XM-400 Configuration Manual

9.3.3.16

redistribute

Description
With this command, you specify which routes are distributed via OSPFv3.
Note
This command is available only with layer 3.
Requirement
● OSPFv3 routing is activated.
● The router is an ASBR router
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
redistribute {static | connected | ripng | bgp}
The parameters have the following meaning:
Parameter
static
connected
ripng
bgp
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The routes are specified that are distributed via OSPFv3.
Further notes
You enable the ASBR router with the
You enable OSPFv3 routing with the
You disable the distribution of the routes with the
You create the information for the routes with the
You display the setting with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
static routes
connected routes
RIPv3 routes
BGP routes
ASBR Router
ipv6 router ospf
show ipv6 ospf
Range of values / note
-
-
-
-
command.
command.
command.
no redistribute
command.
redist-config
command.
Layer 3 functions
9.3 OSPFv3 (IPv6)
529