Unicast-Block - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
Syntax
Call the command without parameters:
no switchport
Result
The interface is configured as a router port.
The command prompt is as follows:
cli(config-if_RPort-Gi$$$)#
Activate the interface again with the
Further notes
You shut down the interface with the
You activate the interface with the
You configure the interface as a switch port with the
You can display the status of this function and other information with the
interface
3.1.13.20

unicast-block

Description
With this command, you enable the blocking of unknown unicast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
unicast-block
Result
Unicast frames are blocked.
100
command.
command.
no shutdown
command.
shutdown
command.
no shutdown
switchport
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
show ip