Show Ip Ospf Request-List - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
Syntax
Call up the command with the following parameters:
show ip ospf neighbor
[{
vlan <vlan-id(1-4094)>|<interface-type><interface-id>
}]
[Neighbor ID]
[detail]
The parameters have the following meaning:
Parameter
Vlan
vlan-id
interface-type
interface-id
Neighbor ID
detail
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The information on the neighboring routers is displayed.
9.2.1.8

show ip ospf request-list

Description
This command shows the request list. This request list contains the information required for
the LSAs.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
446
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Router ID of the neighbor
OSPF information on the neighbor
or
cli#
Range of values / note
-
1 ... 4094
Enter a valid interface.
The ID consists of 4 numbers
each between 0 and 255 and can
match the IP address of the rout-
er.
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10