Dcp Forwarding; Ipv6 Protocol; Clear Ipv6 Traffic - Siemens SCALANCE XM-400 Configuration Manual

Industrial ethernet switches

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

dcp forwarding

With this command, you configure the forwarding behavior of the interface for DCP frames.

PNIO configuration

Since DCP is a PROFINET protocol, the configuration created here is only effective with the

VLAN associated with the TIA interface.

You are in the Interface configuration mode.

The command prompt is as follows:

cli(config-if-$$$)#

Call up the command with the following parameters:

dcp forwarding {block|forward}

The parameters have the following meaning:

The forwarding behavior of the interface for DCP frames is configured.

This section describes the commands relevant for working with IPv6.

With this command, you reset the statistics counters to zero.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 11/2015, C79000-G8976-C252-10

DCP frames are discarded

DCP frames are forwarded

Network protocols

7.2 IPv6 protocol

Range of values / note

Show Quick Links

Table of Contents

Scalance xr-500