Commands In The Global Configuration Mode; Ip Dhcp Server - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
show ip dhcp relay information [vlan <vlan-id>]
The parameter has the following meaning:
Parameter
vlan
vlan-id
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The configuration settings are displayed.
7.5.2

Commands in the Global Configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.5.2.1

ip dhcp server

Description
With this command, you specify the IP addresses of the DHCP servers to which the DHCP
relay agent forwards the frames. You can specify up to four IP addresses for the DHCP relay
agent.
Requirement
● You are in the Global configuration mode.
The command prompt is:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Keyword for a VLAN connection
Number of the addressed VLAN
configure terminal
7.5 DHCPv4 Relay Agent (IPv4)
Range of values / note
-
1 ... 4094
command to change to this mode.
or command and are then in the
end exit
Network protocols
323