Spanning-Tree Bpdu-Transmit - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
Syntax
Call the command without parameters:
no spanning-tree auto-edge
Result
The automatic discovery of a bridge on the interface is disabled.
Further notes
The automatic discovery of a bridge on the interface is enabled with the
edge
6.3.5.7

spanning-tree bpdu-transmit

Description
With this command, you enable or disable the BPDU transmit status at the port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree bpdu-transmit{enabled|disabled}
The parameters have the following meaning:
Parameter
enabled
disabled
Result
The BPDU transmit status has switched over.
240
command.
Description
BPDU packets are transmitted at the
port
BPDU packets are not transmitted at
the port
Range of values / note
Default: enabled
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
spanning-tree auto-