Distribute-List Route-Map - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
Syntax
Call up the command with the following parameters:
no distribute prefix <ip6_add> {in | out}
The parameters have the following meaning:
Parameter
ip6_add
in
out
Result
Filtering is disabled.
Further notes
You enable filtering with the
You display the configured filters with the
9.7.3.5

distribute-list route-map

Description
This command enables the filtering of the routing information according to a route map for
incoming or outgoing routing information.
Requirement
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
616
Description
IPv6 address
The filtering for incoming routing information is
disabled.
The filtering for outgoing routing information is
disabled.
distribute prefix
Values
Enter a valid IPv6 address
-
-
command.
command.
show ipv6 rip filter
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10