Siemens SCALANCE XM-400 Configuration Manual page 515

Syntax
Call up the command with the following parameters:
area <Area-ID> range
[{
}]
{
summary | Type7
}
[tag <tag-value>]
The parameters have the following meaning:
Parameter
Area-ID
IPv6-Prefix
Prefix-Length
advertise
not-advertise
summary
Type7
tag
tag-value
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The address range is configured.
Further notes
You delete the address range with the
You configure the area with the
You can display the status of this function and other information with the
area-range / summary-address
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
<IPv6-Prefix> <Prefix-Length>
advertise | not-advertise
Description
Area ID
IPv6 address
Number of bits belonging to the prefix
(from left to right)
The address range is advertised outside the ranges.
If the Area ID is 0.0.0.0, the router generates an LSA
message of Type 3.
If the Area ID is not 0.0.0.0, the router generates an LSA
message of type 7 in an NSSA.
The address range is not advertised to the outside.
LSA type 3: Inter-area prefix LSA
LSA type 7
Keyword for tag:
Value that is assigned to the aggregated routes.
(optional)
command.
no area range
command.
area
command.
Layer 3 functions
9.3 OSPFv3 (IPv6)
Range of values / note
Specify the ID in the IPv4 address
format
x.x.x.x = 0 ... 255
0.0.0.0 = backbone area
Enter a valid IPv6 address
1 ... 128 bits
128: The node (host) itself
-
-
-
-
-
1 ... 65535
show ipv6 ospf -
515