Commands In The Global Configuration Mode; Ipv6 Mld Snooping - Siemens SCALANCE XM-400 Configuration Manual

Result
The statistics are displayed.
Further notes
You enable MLD snooping with the
You reset the counters to zero with the
8.7.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
8.7.2.1

ipv6 mld snooping

Description
With this command, you enable MLD snooping on the device or on the required VLAN.
For MLD snooping to work, you need to enable the function globally and in the VLANs. In the
Global configuration mode, enable MLD snooping on the device or globally. To enable MLD
snooping on the required VLAN, execute the command in the VLAN configuration mode.
Requirement
● GMRP is disabled.
● You are in the Global configuration mode or in the VLAN configuration mode.
The command prompt is in the Global configuration mode is:
cli(config)#
or in the VLAN configuration mode:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
ipv6 mld snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
ipv6 mld snooping
ipv6 mld snooping clear counters
command to change to this mode.
configure terminal
or
end exit
Layer 2 management protocols
8.7 MLD Snooping (IPv6)
command.
command and are then in the
431