Dhcpv6 Relay Agent (Ipv6); The "Show" Commands; Show Ipv6 Dhcp Relay Statistics - Siemens SCALANCE XM-400 Configuration Manual

Network protocols

7.6 DHCPv6 Relay Agent (IPv6)

Further notes
You configure the device ID with the
You display the IP addresses with the
You display the settings with the
7.6 DHCPv6 Relay Agent (IPv6)
This section describes commands for the DHCPv6 Relay Agent.
7.6.1

The "show" commands

This section describes commands with which you display various settings.
7.6.1.1

show ipv6 dhcp relay statistics

Description
This command displays the DHCPv6 relay agent settings for all or for a selected interface.
Requirement
● The DHCPv6 relay agent is enabled.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ipv6 dhcp relay statistics [interface {vlan <vlan-id(1-4094)> | <interface-type>
<interface-id>} ]
The parameters have the following meaning:
Parameter
interface
vlan
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter, the entries are displayed for all available interfaces.
332
or
cli#
Description
Shows that an interface description follows
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
ip dhcp relay remote-id
show dhcp server
show ip dhcp relay information
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
command.
command.
Range of values / note
-
-
1 ... 4094
Enter a valid interface.