No Ip Ospf Cost - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf cost <cost (1-65535)>
The parameter has the following meaning:
Parameter
cost
Result
The costs are specified.
Further notes
You delete the costs with the
You show the configuration of the OSPF interface with the
command.
9.2.4.6

no ip ospf cost

Description
With this command, you delete the costs.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
486
Description
Costs for the OSPF interface
command.
no ip ospf cost
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 65535
show ip ospf interface
Configuration Manual, 11/2015, C79000-G8976-C252-10