No Ip Rip Send Version; Ripng (Ipv6) - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
ip rip send [demand] version (1 | 2 | 12 | none)
The parameters have the following meaning:
Parameter
demand
1
2
12
none
Result
It has been specified which RIP version outgoing updates need to have.
9.6.4.7

no ip rip send version

Description
This command specifies that there is no restriction relating to the version of outgoing RIP
updates. Updates according to RIPv1 and RIPv2 are sent.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameters:
no ip rip send version
Result
All RIP updates are sent.
9.7

RIPng (IPv6)

This section describes the commands relevant for working with routing with RIPng.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Updates are sent only when requested. -
Only RIPv1 updates are sent.
Only RIPv2 updates are sent.
RIPv1 and RIPv2 updates are sent.
No RIP updates are sent.
Layer 3 functions
9.7 RIPng (IPv6)
Range of values / note
-
-
-
-
607