Show Spanning-Tree Mst Interface - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You display the general settings for the Spanning Tree Protocol with the
command.
6.3.1.10

show spanning-tree mst interface

Description
This command shows port-specific settings of a Multiple Spanning Tree configuration.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with one of the following parameter assignments:
show spanning-tree mst
[<instance-id(1-64)>] interface <interface-type><interface-id>
[{stats|hello-time|detail}]
The parameters have the following meaning:
Parameter
instance-id
interface-type
interface-id
stats
hello-time
detail
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The port-specific settings are displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
or
cli#
Description
Number of the instance or range of
instances whose settings are displayed
Type or speed of the interface
Module no. and port no. of the interface
Shows the number of incoming and
outgoing packets for each path of the
interface
Shows the intervals at which the root
switch sends its "Hello" message to the
other switches
Shows detailed information about the
selected interface
Network structures
6.3 Spanning Tree
show spanning-tree
Range of values / note
1 ... 64
Enter a valid interface
-
-
-
219