Show Interface Access Lists - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.3 MAC access control list
Syntax
Call up the command with the following parameters:
show access-lists [ [{ip | mac}] <access-list-number (1-128)> ]
The parameters have the following meaning:
Parameter
ip
mac
access-list-number
If you do not select any parameters from the parameter list, the configuration of all access
control lists will be displayed.
Result
The configuration of the access control lists is displayed.
11.3.1.2

show interface access lists

Description
This command shows the access control list of one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interface access-lists [<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available interfaces.
698
Description
Selects IP-based access lists (IP ACL)
Selects MAC-based access lists (MAC
ACL)
Number of the access control list
or
cli#
Description
Type or speed of the interface
Module no. and port no. of the interface
Range of values / note
-
-
1 ... 128
Range of values / note
Enter a valid interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10