No Ip Routing - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.1 IPv4 protocol
Syntax
Call the command without parameters:
ip routing
Result
The routing function is enabled.
Further notes
You disable the function with the
You display the setting with the
7.1.2.4

no ip routing

Description
With this command, you disable IPv4 routing function on the device.
Note
IPv6 routing
If IPv6 routing is enabled on the device, this is also disabled with this function.
Note
This command is available only with layer 3.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip routing
Result
IPv4 routing is disabled.
268
command.
no ip routing
command.
show ip route
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10