Show Ipv6 Static Route - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
show ipv6 traffic [
] [hc]
The parameters have the following meaning:
Parameter
interface
vlan
vlan-id
interface-
type
interface-id
hc
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the statistics are displayed for all
available IP interfaces.
Result
The statistics are displayed.
Further notes
You reset the counters to zero with the
7.2.2.6

show ipv6 static route

Description
This command shows the routes that were generated statically.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
interface { vlan <vlan-id> | <interface-type> <interface-id> }
Description
Keyword for the interface via which the statistics
are created.
VLAN
•
Interface
•
Keyword for a VLAN
Keyword for a VLAN connection
Type or speed of the interface
Module no. and port no. of the interface
Display of the High counters parameter
or
cli#
command.
clear ipv6 traffic
Network protocols
7.2 IPv6 protocol
Range of values / note
-
-
1 ... 4094
Enter a valid interface.
-
283